PLANET WGSW-52040 - Manual (Page 853)

63-393
Parameters:
is the target IPv6 address of the ping command. <src-ipv6-address> is the source IPv6
address where the ping command is issued. <hostname> is the target host name of the ping command, which
should not exceed 64 characters.
Default:
Five ICMP6 echo request will be sent by default, with default size as 56 bytes, and default timeout to be 2 seconds.
Command Mode:
Normal user mode
Usage Guide:
When the ping6 command is issued with only one IPv6 address, other parameters will be default. And when the ipv6
address is a local data link address, the name of VLAN interface should be specified. When the source IPv6 address
is specified, the command will fill the icmp6 echo requests with the specified source address for ping.
Example:
(1) To issue ping6 command with default parameters.
Switch>ping6 2001:1:2::4
Type ^c to abort.
Sending 5 56-byte ICMP Echos to 2001:1:2::4, timeout is 2 seconds.
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/320/1600 ms
(2) To issue the ping6 command with source IPv6 address specified.
switch>ping6 src 2001:1:2::3 2001:1:2::4
Type ^c to abort.
Sending 5 56-byte ICMP Echos to 2001:1:2::4, using src address 2001:1:2::3, timeout is 2 seconds.
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
(3) To issue the ping6 command with parameters input interactively.
switch>ping6
Target IPv6 address:fe80::2d0:59ff:feb8:3b27
Output Interface: vlan1
Use source address option[n]:y
Source IPv6 address: fe80::203:fff:fe0b:16e3
Repeat count [5]:
Datagram size in byte [56]: