PLANET WGSW-52040 - Manual (Page 174)

7-173
Parameters:
<integer>: the time out value for the ULDP recovery timer. Its value is limited between 30 and 86400 seconds.
Command Mode:
Global Configuration Mode.
Default:
0 is set by default which means the recovery is disabled.
Usage Guide:
If an interface is shutdown by ULDP, and the recovery timer times out, the interface will be reset automatically. If the
recovery timer is set to 0, the interface will not be reset.
Example:
To set the recovery timer to be 600 seconds.
Switch(config)#uldp recovery-time 600
7.13 uldp reset
Command:
uldp reset
Function:
To reset the port when ULDP is shutdown.
Parameters:
None.
Command Mode:
Globally Configuration Mode and Port Configuration Mode.
Default:
None.
Usage Guide:
This command can only be effect only if the specified interface is disabled by ULDP.