PLANET WGSW-52040 - Manual (Page 60)

1-59
Command mode:
Admin mode.
Usage Guide:
This command is used to show CPU utilization rate in the past 5 seconds, 30 seconds and 5 minutes.
Example:
Show CPU utilization rate.
Switch#show cpu utilization
Last 5 second CPU USAGE: 9%
Last 30 second CPU USAGE: 11%
Last 5 minute CPU USAGE: 11%
From running CPU USAGE: 11%
1.1.33 show memory usage
Command:
show memory usage []
Function:
Show memory usage rate.
Command mode:
Admin and configuration mode.
Usage Guide:
Check the current usage of memory resource by show memory usage command. Only the chassis switch uses
slotno parameter which is used to show the memory usage rate of card on the specified slot, if there is no parameter,
the default is current card.
Example:
Show the current usage rate of the memory.
Switch#show memory usage
The memory total 128 MB, free 58914872 bytes, usage is 56.10%