PLANET WGSW-52040 - Manual (Page 605)

38-145
down boundary of source port; , the up boundary of source port; port3(optional): value of TCP/UDP
destination interface No., Interface No. is an integer from 0-65535; , the down boundary of destination
port;, the up boundary of destination port; [ack] [fin] [psh] [rst] [urg] [syn],(optional) only for TCP
protocol, multi-choices of tag positions are available, and when TCP data reports the configuration of corresponding
position, then initialization of TCP data report is enabled to form a match when in connection; precedence (optional)
packets can be filtered by priority which is a number from 0-7; tos (optional) packets can be filtered by service type
which ia number from 0-15; icmp-type (optional) ICMP packets can be filtered by packet type which is a number
from 0-255; icmp-code (optional) ICMP packets can be filtered by packet code which is a number from 0-255;
igmp-type (optional) ICMP packets can be filtered by IGMP packet name or packet type which is a number from
0-255; , name of time range
Command Mode:
Global mode
Default Configuration:
No access-list configured.
Usage Guide:
When the user assign specific for the first time, ACL of the serial number is created, then the lists are added
into this ACL; the access list which marked 3200-3299 can configure not continual reverse mask of IP address.
Examples:
Permit the passage of TCP packet with source MAC 00-12-34-45-XX-XX, any destination MAC address, source IP
address 100.1.1.0 0.255.255.255, and source port 100.
Switch(config)#access-list 3199 permit 00-12-34-45-67-00 00-00-00-00-FF-FF any-destination-mac tcp 100.1.1.0
0.255.255.255 s-port 100 any-destination
38.7 access-list(mac standard)
Command:
access-list {deny|permit} {any-source-mac | {host-source-mac } | {
} }
no access-list
Functions:
Define a standard numeric MAC ACL rule, no command deletes a standard numeric MAC ACL access-list rule.
Parameters: