PLANET WGSW-52040 - Manual (Page 312)

18-81
Usage Guide:
The secure port must be locked before dynamic MAC clearing operation can be perform in specified port. If no ports
and MAC are specified, then all dynamic MAC in all locked secure ports will be cleared; if only port but no MAC
address is specified, then all MAC addresses in the specified port will be cleared.
Example:
Delete all dynamic MAC in port1.
Switch#clear port-security dynamic interface Ethernet 1/1
18.2.2 show port-security
Command:
show port-security
Function:
Display the secure MAC addresses of the port.
Command mode:
Admin and Configuration Mode.
Default:
The switch is not display port-security configuration.
Usage Guide:
This command displays the secure port MAC address information.
Example:
Switch#show port-security
Security Port MaxSecurity Addr CurrentAddr Security Action
(count) (count)
-----------------------------------------------------------------------------------------------------
Ethernet1/1 1 1 Protect
Ethernet1/3 10 1 Protect
Ethernet1/5 1 0 Protect
-----------------------------------------------------------------------------------------------------
Max Addresses limit in System:128