PLANET WGSW-52040 - Manual (Page 689)

44-229
no radius-server timeout
Function:
Configures the timeout timer for RADIUS server; the “no radius-server timeout” command restores the default
setting.
Parameters:
is the timer value (second) for RADIUS server timeout, the valid range is 1 to 1000.
Command mode:
Global Mode
Default:
The default value is 3 seconds.
Usage Guide:
This command specifies the interval for the switch to wait RADIUS server response. The switch waits for
corresponding response packets after sending RADIUS Server request packets. If RADIUS server response is not
received in the specified waiting time, the switch resends the request packet or sets the server as invalid according
to the current conditions.
Example:
Setting the RADIUS authentication timeout timer value to 30 seconds.
Switch(config)#radius-server timeout 30
44.17 radius-server accounting-interim-update timeout
Command:
radius-server accounting-interim-update timeout <seconds>
no radius-server accounting-interim-update timeout
Function:
Set the interval of sending fee-counting update messages; the no operation of this command will reset to the default
configuration.
Parameters:
is the interval of sending fee-counting update messages, in seconds, ranging from 60 to 3600.