PLANET WGSW-52040 - Manual (Page 294)

17-63
Default:
No MAC address joins the VLAN by default.
Usage Guide:
With this command user can add specified MAC address to specified VLAN. If there is a non VLAN label data packet
enters from the switch port from the specified MAC address, it will be assigned with specified VLAN ID so sent enter
specified VLAN. Their belonging VLAN are the same no matter which port did they enter through. The command
does not have any interfere on the VLAN label data packet.
Example:
Add network device of MAC address as 00-30-4f-11-22-33 to VLAN 100.
Switch#config
Switch(config)#mac-vlan mac 00-30-4f-11-22-33 vlan 100 priority 0
17.3.4 mac-vlan vlan
Command:
mac-vlan vlan
no mac-vlan vlan
Function:
Configure the specified VLAN to MAC VLAN; the “no mac-vlan vlan ” command cancels the MAC VLAN
configuration of this VLAN.
Parameter:
<vlan-id> is the number of the specified VLAN.
Command Mode:
Global Mode.
Default:
No MAC VLAN is configured by default.
Usage Guide:
Set specified VLAN for MAC VLAN.