PLANET WGSW-52040 - Manual (Page 657)

40-197
40.11 show mac-address dynamic count
Command:
show mac-address dynamic count { (vlan <1-4096>)| interface ethernet }
Function:
Display the number of dynamic MAC of corresponding port and VLAN.
Parameters:
<vlan-id> display the specified VLAN ID.
is the name of layer-2 port.
Command Mode:
Any mode
Usage Guide:
Use this command to display the number of dynamic MAC of corresponding port and VLAN.
Examples:
Display the number of dynamic MAC of the port and VLAN which are configured with number limitation function of
MAC.
Switch(config)# show mac-address dynamic count interface ethernet 1/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show mac-address dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------
40.12 show nd-dynamic count
Command:
show nd-dynamic count {(vlan <1-4096>)| interface ethernet }