PLANET WGSW-52040 - Manual (Page 63)

1-62
Display the version information of the switch.
Command mode:
Admin and Configuration Mode.
Usage Guide:
This command is used to show the version of the switch, it includes the hardware version and the software version
information.
Example:
Switch#show version.
1.1.38 username
Command:
username [privilege ] [password [0 | 7] ]
no username
Function:
Configure local login username and password along with its privilege level.
Parameter:
<username> is the username, its range should not exceed 32 characters. <privilege> is the maximum privilege
level of the commands that the user is able to execute, its value is limited between 1 and 15, and 1 by default.
<password> is the password for the user. If input option 0 on password setting, the password is not encrypted; if
input option 7, the password is encrypted (Use 32 bits password encrypted by MD5).
Command Mode:
Global Mode.
Usage Guide:
There are two available choices for the preferences of the registered commands in the switch. They are 1 and 15.
Preference of 1 is for the commands of the normal user configuration mode. Preference of 15 is for the commands
registered in modes other than the normal user configuration modes. 16 local users at most can be configured
through this command, and the maximum length of the password should be no less than 32.
Notice: The user can log in user and priority after the command configures, before issuing the command
authentication line console login local, it should be made sure that at one user has be configured as preference level