PLANET WGSW-52040 - Manual (Page 474)

29-14
is defined as IPv6 general prefix.
Command Mode:
Global Mode.
Default:
IPv6 general prefix is not configured by default.
Usage Guide:
If IPv6 general prefix is configured, the interface will use the configured prefix for IPv6 address generating.
Commonly, the general prefix is used for enterprise IPv6 prefix, and when entering an IPv6 address, users can
simply add the address suffix of to the name of the general prefix. The configured address prefix will be reserved in
the general address prefix pool. At most 8 general prefix can be configured at the same time. When trying to remove
a configured general prefix name, the operation will fail if any interfaces used the configured prefix. Only one general
prefix for a prefix name. The general prefix cannot use the same prefix definition with prefixes learnt from prefix
delegation.
Example:
To set the prefix of 2001:da8:221::/48 to general prefix my-prefix.
Switch(config)# ipv6 general-prefix my-prefix 2001:da8:221::/48
29.18 ipv6 local pool
Command:
ipv6 local pool
no ipv6 local pool
Function:
To configure the address pool for prefix delegation. The no form of this command will remove the IPv6 prefix
delegation configuration.
Parameters:
<poolname> is the name for the IPv6 address pool of the prefix delegation, the length name string should be less
than 32. <prefix/prefix-length> is the address prefix and its length of the prefix delegation. <assigned-length> is
the length of the prefix in the address pool which can be retrieved by the client, the assigned prefix length should be
no less than the value of <prefix-length>