PLANET WGSW-52040 - Manual (Page 645)

39-185
dot1x timeout re-authperiod <seconds>
no dot1x timeout re-authperiod
Function:
Sets the supplicant re-authentication interval; the “no dot1x timeout re-authperiod” command restores the default
setting.
Parameters:
is the interval for re-authentication, in seconds, the valid range is 1 to 65535.
Command mode:
Global Mode.
Default:
The default value is 3600 seconds.
Usage Guide:
dot1x re-authentication must be enabled first before supplicant re-authentication interval can be modified. If
authentication is not enabled for the switch, the supplicant re-authentication interval set will not take effect.
Example:
Setting the re-authentication time to 1200 seconds.
Switch(config)#dot1x timeout re-authperiod 1200
39.26 dot1x timeout tx-period
Command:
dot1x timeout tx-period
no dot1x timeout tx-period
Function:
Sets the interval for the supplicant to re-transmit EAP request/identity frame; the “no dot1x timeout tx-period”
command restores the default setting.
Parameters:
is the interval for re-transmission of EAP request frames, in seconds; the valid range is 1 to 65535.
Command mode: