Metrohm viva 1.1 (ProLab) - Manual (Page 981)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 969
8.4.5.3 Sample changer - Moving
Program part: Manual control
Moving to the desired rack position, lift position or robotic arm position
can be triggered manually here. In addition, the shift rate and lift rate for
the manual changer control can be set here.
Rack position
Set the rack position.
Current position
Shows the current rack position.
Target position
Selection or entry of the rack position to be approached.
Input range 1 - n (depending on rack)
Default value 1
Selection Special beaker 1 - 16
Shift rate
Shift rate for manual control of the sample changer.
Input range 5 - 20 °/s
Default value 20 °/s
[Start]
Starts moving to the target position. After the start, the button changes to
[Stop], the two lower buttons are shown as inactive (gray) and Move... is
shown as status message instead of Ready.
Moves to current rack position –1.
Moves to current rack position +1.
Lift position
Set the lift position for the selected tower.
Current position
Shows the current lift position in mm.
Target position
Selection or entry of the lift position that is to be approached for the cur-
rent rack position (regular beaker, special beaker, external position).