Metrohm viva 1.1 (ProLab) - Manual (Page 344)

4.6 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
332 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Display
on | off (Default value: on)
Indicates whether a measurement curve is displayed in the curve window
or not.
The parameters Area or Height and Relative standard deviation of the area
or height are only displayed in the table if the method contains the CALL
COND command and the Evaluation quantity stop criterion is acti-
vated.
Context-sensitive menu items for table
The table cannot be edited directly but only via the following context-sen-
sitive menu items:
On The check box in the Display column for the selected measurement curve is
activated.
Off The check box in the Display column for the selected measurement curve is
deactivated.
All on All check boxes in the Display column are activated.
All off All check boxes in the Display column are deactivated.
Invert selection The settings in the Display column for the selected measurement curves are
inverted.
Save selection The settings in the Display column for the selected measurement curves are
saved.
Buttons
Selection on
The marking of the curves selected in the table is activated.
Selection off
The marking of the curves selected in the table is deactivated.
4.6.1.2.2 Calibration curve
Tab: Database ▶ Curves # ▶
Calibration curve display
The following elements are displayed in the upper left-hand part of the
curve window:
￭ Axes with labeling (measured quantity and unit)
￭ Calibration points of the standard addition or the calibration curve
￭ Calculated calibration function
￭ Evaluation ratio (line) for calibration method DT