Metrohm viva 1.1 (ProLab) - Manual (Page 311)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 299
NOTE
No measuring point lists can be displayed for curves that have been
generated with a voltammetry command (see Chapter 5.5.2.11.1, page
606).
4.5.2.5.5.2.4 Curve properties
4.5.2.5.5.2.4.1 Curve properties - General parameters
Dialog window: Database / Workplace ▶ Curves # ▶ Properties Curves #
Command type
Shows the command type for which the curve properties are to be
defined.
4.5.2.5.5.2.4.2 Curve properties VA measuring command
Curve properties VA measuring command - x Axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ x Axis
Parameters for the graphical display of the curves on the x axis.
Quantity
Selection of the quantity to be shown on the x axis.
CVS
Selection
Current [A] | Potential [V] | Time [s] | Current
measuring range [A]
Default value Potential [V]
CPVS
Selection
Current [A] | Potential [V] | Time [s] | Current
measuring range [A]
Default value Time [s]
CP
Selection
Current [A] | Potential [V] | Time [s] | Potential
measuring range [V]
Default value Time [s]
Label
Freely definable axis label for the x axis. If auto is selected, then the desig-
nation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto