Metrohm viva 1.1 (ProLab) - Manual (Page 580)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
568 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Shows the instrument type.
Selection IO Controller
Default value IO Controller
Control parameters
Controller description
Selection of the controller output which is to be controlled.
Selection 'Controller name' | not defined
Default value not defined
Controller type
Shows the type of the selected controller output.
Selection Direct controller | Two-point controller | PID
controller | PWM controller
Setpoint value
Setpoint value to which the control is to be set.
This parameter is not displayed when Controller type = Direct control-
ler.
Input range -214783647.000 - 214783647.000 'Mapping
unit of the analog input or of the calculated
value'
Default value 'empty' or default value from the selected
controller 'Mapping unit of the analog input
or of the calculated value'
Control variable
Shows the designation of the analog input port or of the calculated value
(formula entry).