Metrohm viva 1.1 (ProLab) - Manual (Page 973)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 961
[Stop]
Stops preparation for the selected dosing device(s).
8.4.2.4 Dosing - Filling
Program part: Manual control
The filling of dosing units can be started and stopped here. This tab
appears both when a single dosing device or all dosing devices are
selected.
[Start]
Starts filling for the selected dosing device(s).
[Stop]
Stops filling for the selected dosing device(s).
8.4.2.5 Dosing - Emptying
Program part: Manual control
Emptying of dosing units can be started and stopped here. This tab
appears both when a single dosing device or all dosing devices with dos-
ing units are selected.
[Start]
Starts emptying for the selected dosing device(s). In the process, the
parameters defined for the dosing units will be used.
[Stop]
Stops emptying for the selected dosing device(s).
8.4.2.6 Dosing - Dosing a fixed volume
Program part: Manual control
The dosing of a preset volume can be started and stopped here. This tab
only appears if a single dosing device is selected.
Volume
Fixed volume that is to be dosed.
Input range 0.00 - 99,999.9 mL
Default value 1.000 mL
Dosing rate
The volume is dosed at this rate. The maximum dosing rate depends on
the cylinder volume of the dosing unit used. If the entered dosing rate is
too high for the selected dosing device, it will automatically be reduced
during dosing to the largest possible value.