Metrohm viva 1.1 (ProLab) - Manual (Page 48)

2.3 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
36 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Identifica-
tion Description Commands
STY Type of stop with which the command was stopped: 1 = finished normally, 0
= stopped manually with [Quit] or [Stop] CAL MEAS
Opt, CAL
Spec, CVS,
CPVS, CP,
MEAS Opt,
MEAS Opt
Conc, MEAS
Ref, MEAS
Spec, MEAS
TMF, MEAS T
STY Stop type used for stopping the LOOP command: 0 = manual or after error; 1
= maximum number of runs; 2 = maximum run time; 3 = signal ratio; 4 =
condition LOOP
TMF Transmission factor (dimensionless) MEAS TMF
TOL Tolerance within which a measured peak can be assigned to a calibration wave-
length. CAL Spec
TOU Timeout status: 1 = Max. waiting time expired; 0 = Max. waiting time not
expired RECEIVE,
SCAN, TRANS-
FER
UNI Mapping unit which is defined for an IO port in the configuration ANALOG IN,
ANALOG OUT
VOL Dosed volume increment in L ADD STD,
ADD STD,
ADD SAMPLE
DT, ADD STD,
LQH
VOLTOT Dosed total volume in L ADD SAMPLE
DT, ADD STD
2.3.3.5 Evaluation parameter variables
Dialog window: Formula editor ▶ Variables
The automatically calculated evaluation parameter variables are automati-
cally generated by the program for the VA measuring command con-
tained in the method during the evaluation. The Variables field of the
formula editor lists all the variables which are available for the current
method.
Syntax
'ED.Standards.Standard name.Substance name.Variable identifi-
cation'
Examples: 'ED.Standards.Suppressor.Cu.CONC'