Metrohm viva 1.1 (ProLab) - Manual (Page 566)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
554 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
NOTE
If the not defined option is selected, then no ports can be selected in
the Digital outputs tab, because it is not known on which block this
instrument is referenced.
Even if a method is to be created independent of an instrument, an
instrument must still nevertheless be selected for the editing of the
block. One can however set the instrument name back to not defined
afterwards.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Device type field can no longer be edited
and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.
Selection IO Controller | Stepping Motor Controller
Default value IO Controller
5.5.2.8.2.3 DIGITAL OUT - Digital outputs
Tab: Method ▶ DIGITAL OUT ▶ Properties... ▶ DIGITAL OUT - 'Command
name' ▶ Digital outputs
Command name
Name of the command.
Entry 25 characters