Metrohm viva 1.1 (ProLab) - Manual (Page 972)

8.4 Manual control - Functions
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
960 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
￭ General
￭ Preparing
￭ Filling
￭ Emptying
￭ Fixed volume
￭ Dosing
Devices
The dosing functions can be carried out with dosing devices that are built
in or connected to the following instruments:
Voltammetry instrument: 894
Dosing device: 800
Dosing Interface: 846
Sample changer: 814, 815, 858, 919
Photometer: 089
8.4.2.2 Dosing - General
Program part: Manual control
Information on the dosing device selected, the attached dosing unit and
the solution contained therein is displayed here. This tab only appears if a
single dosing device is selected.
Dosing unit
Name
Shows the designation for the dosing unit entered in the configuration.
Cylinder volume
Shows the cylinder volume of the dosing unit.
Solution
Solution
Shows the solution that is assigned to the dosing unit. If no solution is
assigned, ----- is displayed.
8.4.2.3 Dosing - Preparing
Program part: Manual control
Dosing unit preparation can be started and stopped here. This tab appears
both when an individual or all dosing devices are selected.
[Start]
Starts preparation for the selected dosing device(s). In the process, the
parameters defined for the dosing unit will be used.