Metrohm viva 1.1 (ProLab) - Manual (Page 368)

4.7 Subwindow Information
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
356 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
4.6.2.3.5 Curve properties measuring commands - Measuring point list
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ Measuring point
list
Parameters for the display of the measuring point list.
Available columns
Shows all fields that can be displayed as columns in the measuring point
list. The display depends on the command type.
Displayed columns
Shows all fields that will be displayed as columns in the measuring point
list.
Adds the selected column to the measuring point list.
Removes the selected column from the measuring point list.
Changes the sequence of displayed columns by moving the selected col-
umn up and down.
4.7 Subwindow Information
4.7.1 Information - Overview
Subwindow: Database ▶ Information
General
General information about the focused determination in the determina-
tion table is shown in the Information subwindow. The subwindow can
be activated in the Database program part during the definition of the
layout and thus made visible. It can be enlarged and reduced as required;
it can also be maximized.
Tabs
Information about the determination is shown on the following tabs:
￭ Determination
Shows general information about the determination.
￭ Method
Shows general information about the method used.
￭ Sample
Shows general information about the sample used.