Metrohm viva 1.1 (ProLab) - Manual (Page 454)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
442 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Action
894
Selection
Switch on | Switch off | Duration
Default value Duration
Switch on
Switch on the stirrer. The stirrer remains activated, even after the end
of the command.
Switch off
Switch off the stirrer.
Duration
The stirrer can remain switched on for a specific time.
Input range 0 - 9,999 s
Default value 300 s
5.5.2.3.7 RACK
5.5.2.3.7.1 RACK - Overview
Dialog window: Method ▶ RACK ▶ Properties... ▶ RACK - 'Command name'
Command for the initialization of the sample rack in place. The rack
that is in place, the lift and the robotic arm (if present) are reset, the rack
code is read out and the respective rack data is transferred to the sample
changer.
Instruments
This command can be executed with the following instruments:
Sample changer: 814, 815, 858, 919
Appearance
The command has the following appearance:
Parameters
The parameters for the RACK command are configured in the following
dialog window:
￭ RACK - Properties
Command variables
The following command variables are generated by the RACK command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':