Metrohm viva 1.1 (ProLab) - Manual (Page 628)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
616 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Sensors/Electrodes
Working electrode
Selection of an electrode of the Working electrode type from the elec-
trodes of the RDE type present in the electrode table.
Selection RDE | 'Electrode name'
Default value RDE
RDE
Standard electrode of the RDE type, which cannot be deleted.
'Electrode name'
Electrode of the RDE type from the electrode table.
Sensor type
Shows the type of working electrode (RDE).
Reference electrode
Selection of an electrode of the Reference electrode type from the elec-
trodes available in the electrode table.
Selection Reference electrode | 'Electrode name'
Default value Reference electrode
Reference electrode
Standard electrode of the Reference electrode type, which cannot
be deleted.
'Electrode name'
Electrode of the Reference electrode type from the electrode table.
Auxiliary electrode
Selection of an electrode of the Auxiliary electrode type from the elec-
trodes available in the electrode table.
Selection Auxiliary electrode | 'Electrode name'
Default value Auxiliary electrode
Auxiliary electrode
Standard electrode of the Auxiliary electrode type, which cannot be
deleted.
'Electrode name'
Electrode of the Auxiliary electrode type from the electrode table.
Electrode check
The electrode test for the reference and auxiliary electrodes can be acti-
vated and deactivated only in the START command (see "Electrode test
for VA measuring commands", page 579).