9 curves subwindow, 1 curve display, 1 curve display - general – Metrohm viva 1.1 (ProLab) User Manual
Page 180: 2 curve display va measuring command, 1 tabs, Curves subwindow, Curve display, Curves 1, Curves 2
3.9 Curves subwindow
■■■■■■■■■■■■■■■■■■■■■■
168
■■■■■■■■
viva 1.1 (for process analysis)
Background
Selection of the color for the curve background.
Selection
Color selection | white
Default value
white
3.9
Curves subwindow
3.9.1
Curve display
3.9.1.1
Curve display - General
Subwindow: Workplace
▶ Curves #
The Curves 1 and Curves 2 subwindows are subwindows in the Work-
place program part. In these subwindows, the measurement curves and
calibration curves generated by the VA measuring commands during the
ongoing determination are displayed.
The Curves 1 and Curves 2 subwindows can be activated in the Work-
place program part during the definition of the layout and thus rendered
visible. They can be enlarged and reduced as required, and they can also
be maximized.
3.9.1.2
Curve display VA measuring command
3.9.1.2.1
Tabs
Subwindow: Workplace
▶ Curves #
In the curve window, a tab with the corresponding command name is
provided for each run of a VA measuring command. Their sequence is
determined by the method. The upper part of these tabs shows the
recorded voltammograms or calibration curves and the lower part con-
tains information on the individual measurement curves. The
symbols
serve to maximize either the upper or the lower part to the size of the
entire curve window or reset it again.
An icon representing the type of displayed curves is located next to the
title of the tab. You can toggle between the types by clicking on this icon.
Shows the measurement curve (see Chapter 4.6.1.2.1, page
330).
Shows the calibration curve (see Chapter 4.6.1.2.2, page 332).