Metrohm viva 1.1 (ProLab) - Manual (Page 45)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 33
Identifica-
tion Description Commands
FP{x}.MEA Measured value for the fixed point x (1 - 9) in the unit of the measured value MEAS Opt
FP{x}.TEM Temperature for the fixed point x (1 - 9) in °C MEAS Opt
FP{x}.TIM Tim in s until the fixed point x (1 - 9) is reached MEAS Opt
FP{x}.TRN Transmission for the fixed point x (1 - 9) in % MEAS Opt
HR Highest current measuring range used:
1 = 224 mA | 3 = 20 mA | 5 = 2 mA | 7 = 200 µA | 9 = 20 µA | 11 = 2 µA |
13 = 200 nA | 15 = 20 nA | 17 = 2 nA | 19= 200 pA
CVS, CPVS
HR Highest potential measuring range used:
1 = 5 V | 3 = 0.5 V | 5 = 50 mV | 7 = 5 mV
CP
IME Initial measured value (measured value before start conditions are processed) in
the unit of the measured value CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
ITE Initial temperature (temperature before start conditions are processed) in °C CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF,
MEAS T
IVE Value of the input at the end of the command CONTROL
IVS Value of the input at the start of the command CONTROL
LCO Loop counter = current number of completed runs, both of Repeat loops and
While loops CALL COND,
CAL LOOP
Opt, LOOP
LR Lowest current measuring range used:
19= 200 pA | 17 = 2 nA | 15 = 20 nA | 13 = 200 nA | 11 = 2 µA | 9 = 20 µA |
7 = 200 µA | 5 = 2 mA | 3 = 20 mA | 1 = 224 mA
CVS, CPVS
LR Lowest potential measuring range used:
7 = 5 mV | 5 = 50 mV | 3 = 0.5 V | 1 = 5 V
CP
LP.CAx Calculated value x (1 - 3) for the last measuring point on the measuring point list MEAS Opt,
MEAS Opt
Conc
LP.CNT Intensity of the last measuring point in the measuring point list in counts CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc