Metrohm viva 1.1 (ProLab) - Manual (Page 516)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
504 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Event message
Selection of the event message to be waited for, or of the status to be
waited for. The following event messages and statuses can be selected.
Selection 'Event message' | Start
Default value Start
The following event messages and statuses can be selected:
Event/
Status Type Meaning Com-
mands
Start Event The command has just now been
started. All
End Event The command has just now been
ended. All
Busy Status System is in status BUSY, HOLD or
ERROR. All
Finished Status The command is ended. In the event
that the command is run through
several times (e.g. within a LOOP),
the status Finished will be set
already after the first time the com-
mand is ended All
NOTE
An event can only be received as such by the RECEIVE command if it
has been activated at the moment of the event, i.e. it must have been
started prior to the respective event. The occurrence of an event is sent
as a system message, only "listeners" who are already active will
receive, because it is not saved. A status, on the other hand, can be
requested at any time.
Comment
Comment on the event message
Entry 250 characters
Default value 'empty'