3 single determination - status display, 4 single determination - determination parameters, Single determination - status display – Metrohm viva 1.1 (ProLab) User Manual
Page 131: Single determination - determination parameters
■■■■■■■■■■■■■■■■■■■■■■
3 Workplace
viva 1.1 (for process analysis)
■■■■■■■■
119
Interrupt run
The button is enabled (dark gray) in the status BUSY (determination is
running). The button is disabled (light gray) in all other cases. When you
click on [Hold], this button will be replaced in the display by [Cont].
However, [Hold] does not allow you to stop all partial steps of a voltam-
metry command (see Chapter 5.5.2.11.1, page 606).
Continue run
The button is only present in the status HOLD (determination interrupted).
When you click on [Hold], this button will be replaced in the display by
[Cont].
3.6.3.3
Single determination - Status display
Tab: Workplace
▶ Run ▶ Single determination
The current status of the workplace will be displayed on the Single
determination tab:
Status
Selection
READY | BUSY | HOLD | ERROR
READY
Ready for the start of a determination.
BUSY
Determination is running.
HOLD
Determination interrupted.
ERROR
Error.
3.6.3.4
Single determination - Determination parameters
Subwindow: Workplace
▶ Run ▶ Single determination
User
If the option Enforce login with user name is enabled in the security
settings, then the short name of the currently logged-in user will be dis-
played in this field. This field is then not available for editing. If work is
done without login, then a user name can be entered in this field (only in
the status READY).
Entry
50 characters