Metrohm viva 1.1 (ProLab) - Manual (Page 43)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 31
NOTE
In the case of variables with the index {x}, the required number 1 - 9
must be entered for x (e.g., RS.CVS 3.VAR{3}.VTOT for the total vol-
ume in the measuring vessel after the third addition).
If no index is specified, then the last index will be used automatically
(e.g., RS.CVS 3.VAR.VTOT for the total volume after the last addi-
tion).
Identifica-
tion Description Commands
ACO Addition counter = current number of completed runs of the command ADD SAMPLE
DT, ADD STD
BP{x}.CNT Intensity for the break point x (1 - 9) in counts MEAS Opt
BP{x}.MEA Measured value for the break point x (1 - 9) in the unit of the measured value MEAS Opt
BP{x}.TEM Temperature for the break point x (1 - 9) in °C MEAS Opt
BP{x}.TIM Time for the break point x (1 - 9) in s MEAS Opt
BP{x}.TRN Transmission for the break point x (1 - 9) in % MEAS Opt
BSY Command status:
1 = BUSY, HOLD or ERROR
0 = READY
invalid (variable not available) = Command has never been started
All except
START and
END
C0 Coefficient c0 of the calibration curve CAL LOOP
Opt, CAL Spec
C1 Coefficient c1 of the calibration curve CAL LOOP
Opt, CAL Spec
C2 Coefficient c2 of the calibration curve CAL LOOP
Opt, CAL Spec
C3 Coefficient c3 of the calibration curve CAL LOOP
Opt, CAL Spec
CAL Status of the calibration: 1 = calibrated normally, 0 = canceled, because ref-
erence wavelength was not found. CAL Spec
COD Coefficient of determination (R 2 ), which is calculated on the basis of the calibra-
tion function and of the confidence interval.
CAL LOOP Opt
CP{#}.MEA Measured wavelength of the calibration point in nm. If no measured peak can be
assigned, then not found will be entered. CAL Spec
CP{#}.REF Reference wavelength of the calibration point in nm. CAL Spec