Metrohm viva 1.1 (ProLab) - Manual (Page 586)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
574 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
5.5.2.8.8 PORT
5.5.2.8.8.1 PORT - Overview
Dialog window: Method ▶ PORT ▶ Properties... ▶ PORT - 'Command name'
Command for changing the port position on a multi-port valve.
Instruments
This command can be executed with the following instruments:
Titrando: 901, 902, 904, 905, 906, 907
Dosing Interface: 846
Appearance
The command has the following appearance:
Parameters
The parameters for the PORT command are configured in the following
dialog window:
￭ PORT - Properties
Command variables
The following command variables are generated by the PORT command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
EPP Port position after exiting the command: 0 = invalid
position
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
not valid (variable not available) = Command
has not yet been started