Metrohm viva 1.1 (ProLab) - Manual (Page 781)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 769
6.4.2 Device table
6.4.2.1 Device table - User interface
Subwindow: Configuration ▶ Devices
Contents
In the device table the following information about automatically recog-
nized or manually added devices is shown by default:
Device name
Designation of the device.
Device type
Type of device.
Device serial number
Serial number of the device.
Status
Device status. A device that is ready has the status ok shown in green, a
device that is not ready has the not ok status shown in red.
NOTE
The device status is permanently monitored and updated for USB devi-
ces only. For Metrohm devices with RS-232 connection, the current sta-
tus at the last access to the device is shown. For barcode readers and
generic RS-232 devices, the status cannot be monitored. It will be set to
ok after confirmation of the connection test.
Set to work
Date on which the device was added to the device table.
Next GLP test
Date on which the next GLP test is due. If GLP monitoring is enabled and
the set date is before the current date (i.e., the GLP test has not yet been
carried out), then the date will be shown in red.
Remarks
Remarks about the device.