Metrohm viva 1.1 (ProLab) - Manual (Page 618)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
606 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Copy Copies the commands selected in the table to the clipboard.
Cut Deletes the commands selected in the table and copies them to the clipboard.
Paste Inserts the commands that were copied to the clipboard at the end of the table.
5.5.2.11 Voltammetry commands
5.5.2.11.1 Voltammetry commands - Overview
Menu item: Method ▶ Insert ▶ New command... ▶ Voltammetry
The following voltammetry commands (VA measuring commands) can be
selected:
￭ CVS
Electroplating bath analysis with CVS (Cyclic Voltammetric Stripping).
￭ CPVS
Electroplating bath analysis with CPVS (Cyclic Pulse Voltammetric Strip-
ping).
￭ CP
Electroplating bath analysis with CP (chronopotentiometry or open-cir-
cuit potential measurements).
5.5.2.11.2 CVS
5.5.2.11.2.1 CVS - Overview
Dialog window: Method ▶ CVS ▶ Properties... ▶ CVS - 'Command name'
The CVS command is a voltammetry command for the electroplating bath
analysis with CVS (see Cyclic Voltammetric Stripping). It can be inserted
only in VA tracks.
Devices
This command can be executed with the following instruments:
Voltammetry: 894
Appearance
The command has the following appearance:
Principle
In the CVS (Cyclic Voltammetric Stripping) measuring mode, the potential
is changed once or more from the start potential to the 1st vertex poten-
tial, then to the 2nd vertex potential and back to the start potential again