Metrohm viva 1.1 (ProLab) - Manual (Page 661)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 649
Standby potential
Standby potential
The standby potential is applied to the electrodes after completion of the
sweep. It remains in effect until it is switched off manually or until a new
potential is applied to the electrodes. If no standby potential is defined,
then the potential applied to the electrodes is automatically switched off
after completion of the sweep.
Input range –5.000 - 5.000 V (Increment: 0.001)
Selection off
Default value off
5.5.2.11.4.6 CP - Galvanostat
Tab: Method ▶ CP ▶ Properties... ▶ Galvanostat
Command name
Name of the command.
Entry 25 characters
Potential measuring range
Maximum range
Limitation of the highest potential measuring range.
Selection 5 V | 5 mV | 50 mV | 500 mV
Default value 5 V
Minimum range
Limitation of the lowest potential measuring range.
Selection 5 mV | 50 mV | 500 mV | 5 V
Default value 50 mV