Metrohm viva 1.1 (ProLab) - Manual (Page 266)

4.4 Templates
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
254 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Command type
Selection of the command type for which a curve is to be output.
Selection CVS | CPVS | CP | MEAS Ref | MEAS Spec |
MEAS Opt | CAL Spec | MEAS TMF | MEAS T
Default value CVS
Command name
Entry of the command name for which the curve is to be output. If not
defined is selected, all curves present in the determination will be output
with the selected Command type.
NOTE
In addition to the command name, the index also has to be specified in
the format .# (e.g. Chloride.1).
Selection not defined | 50 characters
Default value not defined
Autoscaling
on | off (Default value: on)
If this check box is activated, all axes in the curve window are scaled auto-
matically. In this case, the Start value and End value fields cannot be
edited.
Tabs for VA measuring commands
Additional properties for the curve field can be set on the following tabs:
￭ x axis
Parameters for the graphical display of the curve on the x axis.
￭ y1 axis
Parameters for the graphical display of the curve on the y1 axis (left-
hand y axis).
￭ y2 axis
Parameters for the graphical display of the curve on the y2 axis (right-
hand y axis).
￭ Options
Options for the graphical display of the curve.
Tabs for measuring command
Additional properties for the curve field can be set on the following tabs:
￭ x axis
Parameters for the graphical display of the curve on the x axis.