Metrohm viva 1.1 (ProLab) - Manual (Page 530)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
518 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Identification Description
BP{#}.[MEA] Measured value for the break point (1 - 9) in the unit
of the measured value
BP{#}.CNT Intensity for the break point x (1 - 9) in counts
BP{#}.TEM 1) Temperature for the break point # (1 - 9) in °C
BP{#}.TIM Time for the break point # (1 - 9) in s
BP{#}.TRN Transmission for the break point x (1 - 9) in %
BSY Command status:
1 = BUSY, HOLD or ERROR
0 = READY
invalid (variable not available) = Command has
never been started
DBL Total duration for the processing of the command in
s
EME End measured value (measured value after processing
of the command) in the unit of the measured value
ETE 1) End temperature (temperature after the command
has been processed) in °C
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
invalid (variable not available) = Command has
never been started
FP{#}.[MEA] Measured value for the fixed point # (1 - 9) in the unit
of the measured value
FP{#}.CNT Intensity for the fixed point x (1 - 9) in counts
FP{#}.TEM 1) Temperature for the fixed point # (1 - 9) in °C
FP{#}.TIM Time for fixed point # (1 - 9) in s
FP{#}.TRN Transmission for the fixed point x (1 - 9) in %
IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
ITE 1) Initial temperature (temperature before start condi-
tions are processed) in °C