Metrohm viva 1.1 (ProLab) - Manual (Page 427)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 415
5.5.2.2.4 CALL VMS
5.5.2.2.4.1 CALL VMS - Overview
Dialog window: Method ▶ CALL VMS ▶ Properties... ▶ CALL VMS - 'Command
name'
Command for calling a VA track. The data acquired in the called VA
track is used for the calculation of the VMS value (see Glossary, page
1059) for the standardization of the calibration curves in the calibration
method DT (Dilution Titration) (see Glossary, page 1050). As an option,
you can formulate a condition that must be fulfilled so that the CALL
VMS command is executed.
Appearance
The command has the following appearance:
Parameters
The parameters for the command CALL VMS are set in the following dia-
log window:
￭ CALL VMS
Command variables
The following command variables are generated by the command CALL
VMS in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
BSY Command status:
1 = BUSY, HOLD or ERROR
0 = READY
invalid (variable not available) = Command has
never been started
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
invalid (variable not available) = Command has
never been started