Metrohm viva 1.1 (ProLab) - Manual (Page 567)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 555
Table
The actuation of one digital output is parameterized in each line of the
Digital outputs table.
The Timer function is used with the Start delay and Working time
parameters in order to enable time-staggered parameterization.
One port can not be used more than once within a block.
If a command block originates from a different instrument, the Port
description of which does not exist on the currently selected instrument,
then the affected lines will be displayed in red lettering.
Functions
Moves the selected line up.
Moves the selected line down.
[New]
Opens the Digital output # dialog window in order to edit a new line
(see Chapter 5.5.2.8.2.4, page 555).
[Properties]
Opens the Digital output # dialog window in order to edit the selected
line (see Chapter 5.5.2.8.2.4, page 555).
[Delete]
Deletes the selected line.
5.5.2.8.2.4 DIGITAL OUT - Digital output #
Dialog window: Method ▶ DIGITAL OUT ▶ Properties... ▶ DIGITAL OUT - 'Com-
mand name' ▶ Digital outputs ▶ [Properties] ▶ DIGITAL OUT - Digital output #
Port description
Selection of the digital output. The digital outputs of the selected instru-
ment are available. No port can be selected if not defined is selected in
the Device name field.
Type
Shows the digital output type.