Metrohm viva 1.1 (ProLab) - Manual (Page 543)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 531
Identifica-
tion Description
BSY Command status:
1 = BUSY, HOLD or ERROR
0 = READY
invalid (variable not available) = Command has never
been started
DBL Total duration for the processing of the command in s
EME End measured value (measured value after processing of
the command) in the unit of the measured value
ETE 1) End temperature (temperature after the command has
been processed) in °C
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
invalid (variable not available) = Command has never
been started
IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
ITE 1) Initial temperature (temperature before start conditions
are processed) in °C
LP.CAx Calculated value × (1 - 3) for the last measuring point in
the measuring point list
LP.EXx External value × (1 - 3) for the last measuring point in the
measuring point list
LP.CNT Intensity of the last measuring point in the measuring
point list in counts
LP.MEA Measured value for the last measuring point in the mea-
suring point list in the unit of the measured value
LP.TIM Time in s until the last measuring point in the measuring
point list is reached
LP.TRN Transmission of the last measuring point in the measur-
ing point list in %
MTE Temperature measurement with sensor; 1 = on, 0 = off)
NMP Number of measuring points in measuring point list