Metrohm viva 1.1 (ProLab) - Manual (Page 850)

6.12 Rack data subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
838 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Work position Tower 1
Work position of the selected special beaker at tower 1.
Input range 0 - 235 mm
Work position Tower 2
Work position of the selected special beaker at tower 2.
Input range 0 - 235 mm
Beaker radius
Radius of the selected special beaker on the rack. If the lift is moved to the
work position, then this value will be compared with the Min. beaker
radius parameter (see Chapter 7.3.3, page 852), which can be specifi-
cally defined for each tower. If Beaker radius samples < Min. beaker
radius, then a corresponding error message will appear. With off, the
beaker radius will not be checked.
Input range 1.0 - 100.0 mm
Selection off
Beaker sensor
If the MOVE command is used for moving to the selected special beaker,
then the beaker sensor (Tower, Robotic arm) will check whether a sam-
ple beaker is present or not. With off, no check takes place. For the
Robotic arm option, a Swing Head with beaker sensor must be installed
and a suitable work position with beaker contact must be defined for the
lift, as this position is approached for beaker recognition.
With the Beaker test parameter in the MOVE command, you can deter-
mine whether the determination is to be canceled if a beaker is missing
with or without the display of a corresponding message and whether the
series is to be continued or canceled as well.
Selection Tower | Robotic arm | off