Metrohm viva 1.1 (ProLab) - Manual (Page 428)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
416 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
5.5.2.2.4.2 CALL VMS - Properties
Dialog window: Method ▶ CALL VMS ▶ Properties... ▶ CALL VMS - 'Command
name'
Command name
Name of the command.
Entry 25 characters
Call text
Freely editable text for the designation of the call; the text is displayed in
the command depiction.
Entry 50 characters
Default value 'empty'
Track name
Selection of the VA track to be called up. All of the VA tracks available in
the method are displayed.
Selection 'Track name' | 'empty'
Default value 'empty'
Condition
on | off (Default value: off)
Expression for the condition(s) that can be created or edited with the for-
mula editor after clicking on or by double-clicking in the text field (see
Chapter 2.3, page 21).
If this check box is activated, then the call is carried out only if the evalua-
tion of the condition yields the result 1 (= true).
Entry 1,000 characters
Default value 'empty'
5.5.2.2.5 CALL INTERCEPT
5.5.2.2.5.1 CALL INTERCEPT - Overview
Dialog window: Method ▶ CALL INTERCEPT ▶ Properties... ▶ CALL INTERCEPT -
'Command name'
Command for calling a VA track. The data acquired in the called VA
track is used for calculating the intercept value (see Glossary, page
1053) in the calibration methods MLAT (Modified Linear Approximation
Technique) (see Glossary, page 1054) and LAT (Linear Approximation
Technique) (see Glossary, page 1053). As an option, you can formulate a
condition that must be fulfilled so that the CALL INTERCEPT command
is executed.