Metrohm viva 1.1 (ProLab) - Manual (Page 605)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 593
Command variables
The following command variables are generated by the command
REQUEST in the method run and can be used in formulas under the des-
ignation 'Command name.Variable identification':
Identification Description
BSY Command status:
1 = BUSY, HOLD or ERROR
0 = READY
invalid (variable not available) = Command has
never been started
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
invalid (variable not available) = Command has
never been started
5.5.2.10.2.2 REQUEST - Properties
Dialog window: Method ▶ REQUEST ▶ Properties... ▶ REQUEST - Data input #
Command name
Name of the command.
Entry 25 characters
Sample data request
The sample data that is to be entered not earlier than during the determi-
nation can be selected in the REQUEST - data entry # dialog window.
The Sample data request dialog window, in which the sample parame-
ters selected in the command are requested, appears in the method run
during the processing of this command. The run continues to be stopped
until the entry is confirmed.
NOTE
If the run is not to be stopped, the REQUEST command can be
inserted in a normal track for which the Return immediately check
box is activated.