Metrohm viva 1.1 (ProLab) - Manual (Page 498)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
486 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Identification Description
LP.TRN Transmission of the last measuring point in the mea-
suring point list in %
MTE Temperature measurement with sensor; (1 = on, 0 =
off)
NMP Number of measuring points in measuring point list
STY Type of stop with which the command was stopped:
1 = finished normally, 0 = stopped manually
with [Quit] or [Stop]
1) Command variable is invalid for the Avantes spectrometer
5.5.2.5.4.2 CAL MEAS Opt - General/Hardware
Tab: Method ▶ CAL MEAS Opt ▶ Properties... ▶ CAL MEAS Opt - 'Command
name' ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Device type field can no longer be edited
and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.
Selection Avantes Spectrometer | 089 Photometer
Default value Avantes Spectrometer