Metrohm viva 1.1 (ProLab) - Manual (Page 436)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
424 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Parameters
The parameters for the CALL ELECTROLYTE command are set in the fol-
lowing dialog window:
￭ CALL ELECTROLYTE
Command variables
The following command variables are generated by the CALL ELECTRO-
LYTE command in the method run and can be used in formulas under the
designation 'Command name.Variable identification':
Identifi-
cation Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
FIN Command status:
1 = Command has ended at least once
0 = Command has not yet ended
not valid (variable not available) = Command has
not yet been started
5.5.2.2.7.2 CALL ELECTROLYTE - Properties
Dialog window: Method ▶ CALL ELECTROLYTE ▶ Properties... ▶ CALL ELECTRO-
LYTE - 'Command name'
Command name
Name of the command.
Entry 25 characters
Call text
Freely editable text for the designation of the call; the text is displayed in
the command depiction.
Entry 50 characters
Default value 'empty'