Metrohm viva 1.1 (ProLab) - Manual (Page 356)

4.6 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
344 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Numerical format
Selection of the numerical format for the labeling of the y2 axis.
Selection decimal | scientific | engineering
Default value engineering
decimal
The axis is labeled in the decimal format ±##.### (floating-point num-
ber).
scientific
The axis is labeled in the scientific format ±#.###e±###.
engineering
The axis is labeled in the technical format ±###.###+prefix (engi-
neering format). The prefix (m, µ, n, p) is added to the figure.
Scaling
on | off (Default value: off)
If this check box is activated, then the y2 axis can be manually scaled in
the curve window. In this case, the Start value and End value fields can
be edited. If this check box is not activated, then the y2 axis will be auto-
matically scaled.
Start value
Initial value for scaling the y2 axis.
Editable only when autoscaling is disabled.
Input range
-1.00E+12 - +1.00E+12
Default value -1.00E+12
End value
End value for scaling the y2 axis.
Editable only when autoscaling is disabled.
Input range
-1.00E+12 - +1.00E+12
Default value +1.00E+12
Curve
Axis label
Selection of the color for the designation of the y2 axis.
Selection 13 colors | black
Default value black