Metrohm viva 1.1 (ProLab) - Manual (Page 953)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 941
Selection Document message only | Display and docu-
ment message | Do not start the determina-
tion
Default value Display and document message
Document message only
The message that the validity period has expired will be automatically
saved with the determination.
Display and document message
A message is displayed and you can select whether you want to con-
tinue the run or cancel it. If the run is continued then the message that
the validity period has expired will be automatically saved with the
determination.
Do not start the determination
The determination is not started. The following message must be con-
firmed with [OK].
7.11 Stepping Motor Controller
7.11.1 Stepping Motor Controller - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'De-
vice type' - 'Device name'
The properties of a Stepping Motor Controller are set on the following
tabs:
￭ (see Chapter 7.10.2, page 907)
General device information such as device name, device type, serial
number, etc.
￭ (see Chapter 7.10.3, page 908)
General settings for the IO controller.
￭ (see Chapter 7.10.4, page 908)
Digital inputs of the IO controller.
￭ (see Chapter 7.10.5, page 913)
Digital outputs of the IO controller.
￭ (see Chapter 7.11.6, page 950)
Stepping motors of the IO controller.
￭ (see Chapter 6.5.3.3, page 779)
Information on GLP tests and GLP monitoring.
7.11.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
Device name
Designation of the device, can be freely defined by the user.