6 dialog window load new program version, Dialog window load new program version – Metrohm viva 1.1 (ProLab) User Manual
Page 857
■■■■■■■■■■■■■■■■■■■■■■
7 Devices
viva 1.1 (for process analysis)
■■■■■■■■
845
If it is found during monitoring that the validity period has expired, then
one of the following actions will be triggered automatically during the
start test:
Selection
Document message only | Display and docu-
ment message | Do not start the determina-
tion
Default value
Display and document message
Document message only
The message that the validity period has expired will be automatically
saved with the determination.
Display and document message
A message is displayed and you can select whether you want to con-
tinue the run or cancel it. If the run is continued then the message that
the validity period has expired will be automatically saved with the
determination.
Do not start the determination
The determination is not started. The following message must be con-
firmed with [OK].
7.1.6
Dialog window Load new program version
Dialog window: Configuration
▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'De-
vice type' - 'Device name'
▶ [General ▶ Update] ▶ Load new program version
If it is discovered that the device to be connected has an old program ver-
sion not supported by viva, then it must be updated. To do so, the device
must be selected in the device table and the properties window must be
opened with Edit
▶ Properties.... Afterwards, the Load new program
version dialog window is opened on the General tab with [Update].
Old version
Shows the old device program version.
New version
Shows the new device program version.
[Load]
Loads the new program version. A progress bar is shown during loading.
NOTE
Make sure that the device is not manipulated or switched off during the
loading process, and follow the instructions shown.