Metrohm viva 1.1 (ProLab) - Manual (Page 964)

7.11 Stepping Motor Controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
952 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Reset
The terminal to which the motor is connected is reset. In this process,
the LEDs of the terminal will shortly flash, afterwards it may be neces-
sary to reference again.
Distance
Distance that is to be moved.
Only visible for a stepping motor of the Type = Linear drive.
Input range -214,783,647 - 214,783,647 mm
Default value 0 mm
Angle
Angle that is to be approached.
Only visible for a stepping motor of the Type = Rotary drive.
Input range -214,783,647 - 214,783,647 °
Default value 0 °
Assigned ports
The port information for these ports is automatically read out of the step-
ping motor controller.
Reference position
Shows the port designation.
Safety switch 1
Shows the port designation.
Safety switch 2
Shows the port designation.
Safety switch 3
Shows the port designation.
Brake
Shows the port designation.
NOTE
The assigned ports and the further properties of the stepping motor
(e.g., speed, acceleration, axis feed, etc.) are defined in the IO Control-
Center program.