Metrohm viva 1.1 (ProLab) - Manual (Page 47)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 35
Identifica-
tion Description Commands
MTE Temperature measurement with sensor; 1 = on, 0 = off) CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
NMP Number of measuring points in measuring point list CAL MEAS
Opt, CVS,
CPVS, CP,
MEAS Opt,
MEAS Opt
Conc, MEAS
TMF, MEAS T
OUT Number of outliers CAL LOOP Opt
OVE Value of the output at the end of the command. Direct controller/2-point control-
ler: 1 = active, 0 = inactive
PID/PWM: –100 to 100% (value of the analog output or the pulse frequency)
CONTROL
OVS Value of the output at the start of the command. Direct controller/2-point con-
troller command status: 1 = active, 0 = inactive
PID/PWM: –100 to 100% (value of the analog output or the pulse frequency)
CONTROL
PK{x}.ABS Absorbance of the peak x (1 - 9) in mAU MEAS Spec
PK{x}.TRN Transmission of the peak x (1 - 9) in % MEAS Spec
PK{x}.CNT Intensity of the peak x (1 - 9) in counts MEAS Spec
PK{x}.CNR Intensity of the peak x (1 - 9) in the reference spectrum in counts MEAS Spec
PK{x}.CND Intensity of the peak x (1 - 9) in the dark spectrum in counts MEAS Spec
PK{x}.WVL Wavelength of the peak x (1 - 9) in nm MEAS Spec
PK{x}.SAT Detector with peak x (1 - 9) saturated: 1 = saturated;0 = not saturated MEAS Spec
RPM Stirring rate in min –1 CVS, CPVS, CP
RAN Current absolute rotation angle of the rack in ° in relation to the axis of the
selected tower (entry when exiting the command) MOVE
RPO Current rack position (entry when exiting the command); 0 means 'not defined' MOVE
SAN Current absolute swing angle of the robotic arm in ° (entry upon exiting the com-
mand) MOVE, SWING
SDV Actual value of the standard deviation when the command is canceled CALL COND
SPO Current external position (entry when ending the command); 0 means invalid
position SWING
SRAT Signal ratio at the most recent command run. LOOP
STC{x} Concentration of the standard x (1 - 50) used for the command CAL LOOP Opt