Basler Electric DGC-2020 - Manual (Page 565)

9400200990 Rev X DGC-2020 Modbus
™ Communication
B-133
Holding
Register
Parameter Range
Read/Write
Supported
Data
Format
Units
40471 Speed Upper Limit 0 to 2500 rpm R Raw ECU Parameter Data
10 rpm/bit gain, 0 rpm offset
40472 Torque Lower Limit 0 to 125% R Raw ECU Parameter Data
1%/bit gain, -125% offset
40473 Torque Upper Limit 0 to 125% R Raw ECU Parameter Data
1%/bit gain, -125% offset
40474 Crankcase Pressure -250 to +251.99
kPa R Raw ECU Parameter Data
0.0078125 kPa/bit gain,
-250 kPa offset
40475 Oil Filter Diff. Pressure 0 to 125 kPa R Raw ECU Parameter Data
0.5 kPa/bit gain, 0 offset
40476 Fuel Filter Diff. Pressure 0 to 500 kPa R Raw ECU Parameter Data
2 kPa/bit gain, 0 offset
40477-82 FUTURE USE
40493-99 FUTURE USE
40500 DGC-2020 product series identifier 2020
R
40501 Firmware Part Number - 2nd most
significant digit. NOTE: The most
significant digit is always 9, but is
not mapped. 0 - 9
R
40502 Firmware Part Number - 3rd-6th
most significant digits 0000 - 9999
R
40503 Firmware Part Number - four least
significant digits 0000 - 9999 R
40504 LED Status individual bits
are 0 or 1 R Bits indicate status of LED’s:
b0 = RUN
b1 = OFF
b2 = AUTO
b3 = ALARM
b4 = LOAD
b5 = NOT IN AUTO
40507 Read Relay Image of both Main
and Aux Output
(Duplicate of 40298) individual bits
are 0 or 1 R Main is in lower byte and Aux is in
upper byte.
b0 = Aux Output 1,
b1 = Aux Output 2,
b2 = Aux Output 3,
b3 = Aux Output 4,
b4 = Aux Output 5,
b5 = Aux Output 6,
b6 = Aux Output 7,
b7 = Aux Output 8.
b8 = Master Start Relay,
b9 = Fuel Solenoid Relay,
b10 = PreHeat PreLube Relay,
b11 = Alarm Relay,
b12 = UNASSIGNED,
b13 = Buzzer On,
b14 = EPS Loaded Relay,
b15 = PreAlarm Relay,
40508 Input Contacts States
(Duplicate of 40273) individual bits
are 0 or 1 R b0 = coolant level,
b1 = ATS,
b2 = E-stop,
b3 = charger failed,
b4 = aux. input 1,
b5 = aux. input 2,
b6 = aux. input 3,
b7 = aux. input 4.
/* b7 =
aux. input 4. */
40509-604
RESERVED
OVERCURRENT
40605 51 Pick-up – 3-phase 18-118,
90-775 R W 0.18-1.18 Aac for 1A CTs,
0.90-7.75 Aac for 5A CTs