Basler Electric DGC-2020 - Manual (Page 139)

•
Auxiliary Input X Closed (X = 1 to 16)
•
AVR Output Limit
•
Battery Charger Fail Status
•
Battery Overvoltage Pre-Alarm
•
CEM Comm Failure
•
Common Alarm
•
Common Pre-Alarm
•
Config Element X Status (X = 1 to 8)
•
Coolant Temp Sender Fail Alarm
•
Coolant Temp Sender Fail Pre-Alarm
•
Cooldown Timer Active
•
DEF Fluid Low Pre-Alarm
•
DEF Fluid Empty Pre-Alarm
•
DEF Engine Derate Pre-Alarm
•
DEF Pre-Severe Inducement Pre-Alarm
•
DEF Severe Inducement Pre-Alarm
•
DEF Inducement Override Pre-Alarm
•
DPF Regeneration Inhibited
•
Low Coolant Level Status
•
Low Coolant Temp Pre-Alarm
•
Low Fuel Alarm
•
Low Fuel Pre-Alarm
•
Low Oil Pressure Alarm
•
Low Oil Pressure Pre-Alarm
•
LSM Comm Failure
•
MPU Speed Sender Fail Alarm
•
Oil Pressure Sender Fail Alarm
•
Oil Pressure Sender Fail Pre-Alarm
•
Overcrank Alarm
•
Overspeed Alarm
•
Scheduled Maintenance Pre-Alarm
•
Switch Not in Auto
•
Transfer Fail Alarm
•
Virtual Output X Status (X = 1 to 8)
•
Unexpected Shutdown Alarm
•
Weak Battery Voltage Pre-Alarm
Dial-Out
The DGC-2020 uses telelocator alphanumeric protocol (TAP) version 1.7 when communicating with
paging companies. This data format
D specifies seven data bits with even parity. If required, eight data bits
with no parity can be specified.
The message string sent by the DGC-2020 can be limited to a length supported by the receiving pagers E .
If a message to be transmitted by the DGC-2020 exceeds the pager message limit, the DGC-2020 will
make multiple calls to transmit the complete message.
Dial-out messages are sent by the DGC-2020 at a user-defined interval F . This interval gives an operator
the opportunity to dial into the DGC-2020. A second user-defined interval G determines how frequently dial-
out attempts are made following a dial-out failure.
You may need to include a “1” or the area code, or both. If you are not sure you need the extra numbers,
dial the phone number on your telephone. If the modem handshake is heard, the number dialed is
correct.
Dial-In
When the DGC-2020 modem shares a line used for voice communication, the number of rings H required
for the modem to answer can be increased to allow time for an operator to answer an incoming telephone
call. Additional settings can be adjusted by use of modem initialization string
I commands.
The BESTCOMSPlus ® Modem Setup screen is illustrated in Figure 4-23.
Figure 4-23. Modem Setup
9400200990 Rev X DGC-2020 BESTCOMSPlus
® Software
4-29