Basler Electric DGC-2020 - Manual (Page 322)

breaker commands, connect a “Logic 0” input object to the open and close command
inputs of the breaker block.
c. Click the Save button when the logic is complete.
d. From the Communication pull-down menu, select Upload Logic to load the logic into the
DGC-2020 if you are connected to it, or save the settings file if you are working off line.
5. Set the parameters for detecting stable and failed bus and generator under SETTINGS EXPLORER >
BREAKER MANAGEMENT > BUS CONDITION DETECTION.
Front Panel Navigation Path: SETTINGS > BREAKER MANAGEMENT > BUS CONDITION DETECT
a. Generator Sensing. See Figure 7-38.
Figure 7-38. Settings Explorer, Breaker Management, Bus Condition Detection
7-34 DGC-2020 Setup 9400200990 Rev X