Basler Electric DGC-2020 - Manual (Page 10)

BESTCOMSPlus®
Version and Date
Change
2.05.00, 07/09 •
Made a correction to announce a message that logic will not be saved
if the maximum number of logic gates on any one level has been
exceeded.
•
On the Breaker Management, Breaker Hardware screen, changed the
Gen and Mains Breaker Closing Time from 0.1-600 in increments of
0.1 to 0-800 in increments of 5.
•
Corrected Settings Compare error when there are remote outputs or
logic control relay outputs in the logic diagram.
2.04.01, 05/09
•
Changes invisible to the user.
2.03.01, 02/09 •
Added “P” (programmable) curve selection for the 51 function.
•
Improvement to allow spaces in Initializing Message 1 & 2 on General
Settings, Front Panel HMI screen in the Settings Explorer.
•
Improved backwards compatibility.
•
Improved Commission Date setting on Run Statistics screen in the
Metering Explorer.
2.03.00, 12/08
•
Added support for CEM-2020H.
•
Added Export to File feature.
•
Added settings for Phase Toggle and Initializing Messages on General
Settings, Front Panel HMI screen.
•
Re-arranged CANbus Setup screen and added ECU Setup screen
under Communications.
•
Added settings for 51-3 element under Generator Protection, Current.
•
Added setting for Off Mode Cooldown on System Parameters, System
Settings screen.
•
Added Remote Module Setup screen under System Parameters.
•
Added Remote LSM Inputs settings and metering screens under
Programmable Inputs.
•
Added settings to Bias Control screens for Var/PF control.
•
Added kvar A, B, C, and Total to Power and Summary metering
screens.
•
Re-arranged MTU metering screens.
•
Added MTU Status screen and MTU Engine Status screen.
•
Added BESTlogicPlus Input Objects for Configurable Elements,
Configurable Protection, Front Panel Buttons, PF Mode Active, Pre
Start Input, and Run Input.
•
Added BESTlogicPlus Pre-Alarms for Checksum Fail and CEM
Hardware Mismatch.
•
Added BESTlogicPlus Elements for 51-3, COOLSTOPREQ,
COOLDOWNREQ, EXTSTARTDEL, PRESTARTOUT, RUNOUTPUT,
STARTDELBYP, and STARTOUTPUT.
•
Added Relay Control settings on System Parameters, System Settings
screen.
2.02.01, 10/08 •
Maintenance release (BE1-11 changes)
2.01.00, 05/08 •
Added settings for AEM-2020.
•
Added settings for Automatic Generator Protection.
•
Added settings for Integrating Reset on 51 function.
•
Added settings for Configurable Protection.
2.00.01, 03/08 •
Added settings for CEM-2020.
1.04.01, 11/07 •
Added settings for LSM-2020.
viii DGC-2020 Introduction 9400200990 Rev X